Cut-Off machines are versatile and
cut nearly all materials in slabs, sections, tubes
and bars. The cutting is by hand feed. It works at amazingly high speeds so
that a solid m. s. bar of 25 mm dia is cut in almost 20 seconds. 60 x 60 x 8mm section in 25 seconds
and 75 mm. dia pipe in 30
seconds, the Drive to cut-off wheel is from a motor through a set of vee belts on the wheel spindle. Motor is positioned on a
hinged platform with counter-balancing spring for
easy operation. An adjustable depth stop prevents accidental damages to
cut-off wheel and regulates depth of cut. Cut-Off wheel spindle runs in
pre-loaded bearings and is equipped with recessed flangs an adequate guard. Floor Stand Heavy gauge sheet
metal fabricated is braced for rigidly. Firm bolting to foundation is
necessary when machine is put into operation. The starter with convenient reach is flush mounted on one side of the stand. Coolant Pump An independently driven motorised with
tank having sward partion, Coolant Pump An independently driven motorised with
tank having sward partion, pipes and spout is an extra equipment.
lt may be
used only when high speed steel circular saw blade is used. Coolant is not required when used with abrasive wheel. Quick Cutting operation yields good
cutting surface. For cutting ferrous metals or hard materials, aluminium oxide wheels (of normal corundum) i.e., soft
wheels are recommended. For non-ferrous or soft materials, silicon carbide cut-off .wheels or metal cutting saws are recommended.
Reinforced cut-off wheels minimize accidental
breakages, last longer than normal cut-off wheels and are safe
to operate. The life of grinding wheel mostly depends on the amount of work,
material, size, strength or hardness of material, its
alloy components etc. The Clamping Vice-Head unit in both
AMI-16 and AMI-12 is "Quick Action
Type". In AMI-16 it is tubular in which the the screw is entirely protected from the abrasive dust
and hence the wear & tear of the screw is almost nil.In AMI-12 the screw vice is cam-actuated to clamp the job
Standard Equipment :
motor, starter and vice.
- Coolant attachment with tank unit and flow control nozzles-pipe fittings (Not recommended to use with
abrasive wheels. It may be used with H.S.S. saw blades only.)
extraction Unit: With 1 H.P. motor and filters, complete with suction mouth and pipe connections and spark
- Quick action vice for repeated operation on same job.
- Cut-off wheal.
- Carbide tipped saw blade.
- High speed steel saw blade.
- Set of pulleys for speed reduction.
- 1400 R.P.M. motor.
- Two speed pole changing motor 1400 & 2800 R.P.M. motor.
- Adjustable bar support stand.