180° adjustable front support arm with linear guide (below 160T)
X,Y axis servo motor control
Amada standard punch & dies
Hydraulic Clamp (Top & Bottom) - Wila
Front support arm with two linear guide
Front light curtain
Rear light curtain
Front laser protection
Air cooling system
Motorized Z axis
R1, R2 axis
Z1, Z2 axis
X1, X2 axis
The main mechanical structure of the press brake consists of the frame, column, ram, worktable, the main cylinder and backgauge. The main components are through finite element analysis and optimized design by 3D software to fully guarantee the structural strength and rigidity of each component.
The foundation of every ADH press brake is a solid, mono-block frame which made from high yield steel. Which means our press brakes will perform accurately and reliably year after year. We' re so confident in our frames so that we offer a 15-year warranty with our standard machines.
Our WAD series press brake can be equipped with Delem DA52s, DA58T, DA66T controller and Esa S530, S630 controller. The selection of the controller should be based on practical use and budget.
The motor of our press brake is adopt world famous brand "Siemens", which will not only has low noise during working of the machine but also has longer service life.
Amazing low noise, made of high strength cast iron and unique design for inner noise reduction
Low sensitivity to oil pollution and assure of long service life
Our press brake machine uses Hoerbiger integrated hydraulic control system that limits the number of pipe connections, making it more reliable and easy for maintenance.
Our press brake adopt Schneider electrical components. The high quality electric parts can make the machine performing well even the electricity is not stable and customers can easily get the replacement anywhere in the world.
We using the Taiwan HIWIN back screw and linear to ensure the moving of X-axis with higher accuracy than using rod. And the backgauge adopt timing belt & wheel mechanism which controlled by servo motor instead of step motor. The height of the backgauge finger can be adjusted manually. Totally there're THREE pcs of backgauge fingers for positioning.
The standard equipped fast clamp will help you replace the top punch in very short time. Convenient and time-saving.
Punch & Die
The standard top punch and dual-V bottom die are specially designed for bending sheet metals. More press brake toolings can be selected as per your practical use.